Nach der Installation des fglrx-Treibers mit Kanos Script funktioniert xawtv nicht mehr, Fehlermeldung:
Code:
xawtv
This is xawtv-3.95.dfsg.1, running on Linux/i686 (2.6.22-10-kanotix)
WARNING: Your X-Server has no DGA support.
WARNING: couldn't find framebuffer base address, try manual
configuration ("v4l-conf -a <addr>")
ioctl: VIDIOC_OVERLAY(int=1): Das Argument ist ungültig
ioctl: VIDIOC_OVERLAY(int=1): Das Argument ist ungültig
ioctl: VIDIOC_OVERLAY(int=1): Das Argument ist ungültig
Ich verwende eine analoge TV-Karte (Brooktree Corporation Bt878 Video Capture (rev 11)) mit einer Onboard-ATI-Grafikkarte (VGA compatible controller: ATI Technologies Inc Radeon X1200 Series, Mainboard Asus M2A-VM für Sockel AM2) unter Thorhammer-RC5B. Mit dem vesa-Treiber kann ich das Fernsehbild sehen, habe auf meinem Röhrenmonitor aber nur 60Hz Bildwiederholfrequenz. Auszug aus xorg.conf:
Code:
Section "Device"
### Available Driver options are:-
# sw_cursor is needed for some ati and radeon cards
#Option "sw_cursor"
#Option "hw_cursor"
#Option "NoAccel"
#Option "ShowCache"
#Option "ShadowFB"
#Option "UseFBDev"
#Option "Rotate"
Option "RenderAccel" "1"
# more speed for beryl/compiz
Option "XAANoOffscreenPixmaps" "1"
Identifier "Card0"
# The following line is auto-generated by KANOTIX mkxf86config
Driver "fglrx"
Option "UseInternalAGPGART" "no"
Option "VideoOverlay" "on"
Option "OpenGLOverlay" "off"
Option "MonitorLayout" "AUTO, AUTO"
VendorName "All"
BoardName "All"
#BusID "PCI:1:0:0"
EndSection
Wer kann helfen? |